tempering

Tempering by grinding heat causes hardness change at the surface of the hardened steels.

磨削热导致回火引起淬硬钢磨削后表面硬度变化.

When the tempering temperature is higher, the microstructure and the property is unusual.

回火温度过高会出现组织性能的异常变化。

However, most are now predicting a short term tempering of Usd buying.

然而, 大多数的分析师预计,将会有个短期的美元买入的回调过程.

The other reasons were lower tempering temperature and slower temper cooling rate.

回火温度偏低及回火冷却速度偏缓等，是零件冲击韧度不足的另一原因。

The tempering smell of the cream cake almost made me forget I was on a diet.

奶油蛋糕很香啊,我差点忘了自己是在节食.

We have been in the midst of tempering.

这一回就是一次锻炼.

The line has perfect performances and is widely used for hardening and tempering bearing parts.

该生产线消化吸收国外先进技术,性能优越,主要用于轴承零件的淬、回火.

In diffusion layer , cracks were found after hardening and tempering.

调质使得扩散层产生裂纹.

Don't we talk about tempering?

不是讲锻炼 吗 ?

It was a kind of tempering for us.

这对我们是一种锻炼.

Ten influence factors of Quenching and Tempering Temperature Choice for Die& Mold Steel

模具钢淬火回火温度选择的十种影响因素

When rising tempering temperature to the range of 300~ 375 ℃, impact toughness of the steel is decreased to the lowest.

回火温度升至330～375℃时，冲击韧性降至最低；

It's a new process for tempering steel.

这是一种新的炼钢方法.

The results showed that two of surfacing layers under 850 ℃ air cooling, 850 ± 5 ℃ oil cooling and 400 ℃ tempering had higher hardness and better wear corrosion resistance, and the technological processes were simplified as well.

结果表明，两种硬质合金堆焊层经850℃空冷、850±5℃油淬+400℃回火后，均具有较高的硬度和优异的耐腐蚀磨损性能，且简化了表面处理工艺。

We human beings need tempering too.

我们人也要锻炼.

Temperance is, on a surface level, about " tempering. "

表面上来看, 与节制相关的是 “ 调和 ”.

A lower tempering temperature is suggested.

鉴于两个钢种目前推荐的回火温度较高，建议适当降低回火温度。

At high temperature uses are: sintering, welding, hardening, sintering, tempering, Xu cold.

在高温下使用用途有: 烧结 、 焊接 、 淬火 、 烧成 、 回火 、 徐冷.

When tempering properly, the milling property of wheat and flour quality could be greatly improved.

调质既能显著改变小麦的制粉特性,同时对小麦粉的品质也会产生一定的影响.

The effect of Tempering Temperature on Microstructure and Mechanical Behavior of Spring Steel

回火温度对弹簧钢微观组织和力学行为的影响

Tempering Temperature Measurement of Mining Circular Chain Using Bi-Sensors

采用双传感器的矿用圆环链差温回火温度检测

Didn't you say you wanted tempering?

你们不是讲锻炼 吗 ?

The results show that quenching temperature, tempering temperature and holding time are determining factors.

结果表明：加热温度、回火温度、保温时间起着决定性作用；

Fatigue strength of the MIM specimens declined with increasing tempering temperature.

MIM钢试样的疲劳强度随着回火温度升高而减低。

Keywords: ultra-low carbon bainitic steel, tempering, transmission electron microscopy.

关键词: 超低碳变韧铁合金钢 、 回火 、 穿透式电子显微镜.

Tempering temperature remarkably affect the threshold value of fatigue crack propagation.

回火温度对该钢的疲劳裂纹门槛值影响显著。

The Effect of Tempering Temperature on Properties of an Armour Steel

回火温度对装甲钢性能的影响

The hardness increases again when tempering temperature is higher than 525 ℃.

回火温度超过525℃后，韧性又出现提高。

Therefore, it is important to properly control the tempering temperature during the second stage heat treatment.

因此，在珠光体可锻铸铁第二阶段热处理时，应主要控制好回火温度。

Effect of Tempering Temperature on Structures and Properties of Ni-Cr-Al Hard Elastic Alloys

回火温度对Ni－Cr－Al硬弹合金组织和性能的影响