trunk lid

Finite Element Analysis and Testing on the Trunk Lid of Fukang 988

富康988轿车行李箱盖有限元分析及试验

The parameters optimization of the stamping drawing process of the outer panel of trunk lid is a multifactor and multiobjective problem. The robust optimal design was adopted for this characteristic.

行李箱盖外板冲压拉延成形的工艺参数优化是一个多因素多目标问题，针对该问题的特点，采用本文的稳健优化设计方法。

Airhostess, the lid of the luggage trunk won't shut.

航空小姐，放行李的盖子关不上。

Mechanical Analysis of Trunk Lid Hinges of FN-Car and the Application to Torsion-Bar Design Alteration

FN轿车行李箱盖铰链受力分析及其在扭杆设计中的应用

He shut the lid and pressed the lock, when away flew the trunk up the chimney with the merchant's son in it, right up into the clouds.

他关上了盖子，按下了锁，离开时飞越了与商人的儿子在里面，直到入云烟囱主干。

Taking the mould design of hinge installed plates which used for trunk lid of cars as an analyzed object, a study for mould virtual debugging was carried out based on AUTOFORM.

以汽车行李箱铰链安装板的模具设计为分析对象，进行了基于A UT OFORM的模具虚拟调试的研究。

It is shown that the forming method of dangerous parts in trunk lid inner panel belongs to bulge deep drawing deformation. The cold rolled sheet with relatively high r value and n value can obtain higher forming limit, correspondingly the forming safe allowance is relatively high.

结果表明：行李箱内板危险部位的变形方式为胀形&深拉延变形，r值和n值较高的冷轧薄板具有较高的成形极限，相应地其冲压成形安全裕度也较大。

Open trunk lid, inspect the area around the trunk cylinder.

打开主体盖，检查主体孔周围的地方。

Analysis of stamping process for trunk lid inner panel

行李箱内板零件冲压成形分析

In fact, we're barely seeing any traditional Lagonda cues, apart from the large grille, thick C-pillar, and rotund trunk lid.

事实上，我们几乎没有看到任何传统拉贡达线索，除了大格栅，厚C柱，并腴躯干盖子。

Install push-in fasteners holding trunk lid slam bumpers to top of fascia.

安装将行李厢盖沿保险杆紧固到面板顶部上的推进式固定件.

He slammed down the lid of a trunk.

他砰地一声关上箱盖.

An otherwise nice exterior design is ruined by the oddly shaped trunk lid.

一个漂亮的外观设计，否则破坏了形状怪异的行李箱。